規格 16Mx32
類型 LPDDR2
電壓 1.2/1.8V
刷新 4K
腳位/封裝 BP = PoP BGA
狀態 Prod
型號別 IBIS-43, IBIS-46
產品系列 46 = 車規DDR/DDR2/DDR3/DDR4
總線寬度 32 = x32
字數 160 = 16M
代/版本 A
焊接 L = SnAgCu
温規 A2 = 車規 (-40C to +105°C)
外包裝 卷轴包

IS46LD32160A-18BPLA2-TR 特徵

  • Low-voltage Core and I/O Power Supplies VDD2 = 1.14-1.30V, VDDCA/VDDQ = 1.14-1.30V, VDD1 = 1.70-1.95V
  • High Speed Un-terminated Logic(HSUL_12) I/O Interface
  • Clock Frequency Range : 10MHz to 533MHz (data rate range : 20Mbps to 1066Mbps per I/O)
  • Four-bit Pre-fetch DDR Architecture
  • Multiplexed, double data rate, command/ad- dress inputs
  • Four internal banks for concurrent operation
  • Bidirectional/differential data strobe per byte of data (DQS/DQS#)
  • Programmable Read/Write latencies(RL/WL) and burst lengths(4,8 or 16)
  • ZQ Calibration
  • On-chip temperature sensor to control self re- fresh rate
  • Partial
    • array self refresh(PASR)
  • Deep power-down mode(DPD)
  • Operation Temperature Commercial (TC = 0°C to 85°C) Industrial (TC = -40°C to 85°C) Automotive, A1 (TC = -40°C to 85°C) Automotive, A2 (TC = -40°C to 105°C) options

概觀

Clock: CK and CK# are differential clock inputs. All Double Data Rate (DDR) CA inputs are sampled on both positive and negative edge of CK. Single Data Rate (SDR) inputs, CS# and CKE, are sampled at the positive Clock edge. Clock is defined as the differential pair, CK and CK#. The positive Clock edge is defined by the crosspoint of a rising CK and a falling CK#. The negative Clock edge is defined by the crosspoint of a falling CK and a rising CK#. Clock Enable: CKE HIGH activates and CKE LOW deactivates internal clock signals and therefore device input buffers and output drivers. Power savings modes are entered and exited through CKE transitions. CKE is considered part of the command code. See Command Truth Table for command code descriptions. CKE is sampled at the positive Clock edge. Chip Select: CS# is considered part of the command code. See Command Truth Table for command code descriptions. CS# is sampled at the positive Clock edge. DDR Command/Address Inputs: Uni-directional command/address bus inputs. CA is considered part of the command code. See Command Truth Table for command code descriptions. Data Inputs/Output: Bi-directional data bus.