IS46LD16160A-25BLA2-TR

Density 256Mb
Org 16Mx16
Pkg(Pins) BGA
Vcc 1.2/1.8V
Refresh 4K
No. of Words 16M
Models IBIS-43, IBIS-46
Solder SnAgCu
Status Prod
Outpack Tape on Reel
Type LPDDR2
Bus Width 16 = x16
Speed(Mhz) up to 400 Mhz
Temp.Range Automotive Grade (-40C to +105°C)
Generation/Rev A
Product Family 46 = DDR/DDR2/DDR3/DDR4 Automotive grade
Temp. Grade A2 = Automotive Grade (-40°C to +105°C)
Solder Type L = SnAgCu
Generation A = A
Number Of Words 160 = 16M
Speed 25 = 400MHz
Operating Voltage Range LD = 1.2V - 1.8V LPDDR2
Package Type B = BGA

IS46LD16160A-25BLA2-TR Features

  • Low-voltage Core and I/O Power Supplies VDD2 = 1.14-1.30V, VDDCA/VDDQ = 1.14-1.30V, VDD1 = 1.70-1.95V
  • High Speed Un-terminated Logic(HSUL_12) I/O Interface
  • Clock Frequency Range : 10MHz to 533MHz (data rate range : 20Mbps to 1066Mbps per I/O)
  • Four-bit Pre-fetch DDR Architecture
  • Multiplexed, double data rate, command/ad- dress inputs
  • Four internal banks for concurrent operation
  • Bidirectional/differential data strobe per byte of data (DQS/DQS#)
  • Programmable Read/Write latencies(RL/WL) and burst lengths(4,8 or 16)
  • ZQ Calibration
  • On-chip temperature sensor to control self re- fresh rate
  • Partial
    • array self refresh(PASR)
  • Deep power-down mode(DPD)
  • Operation Temperature Commercial (TC = 0°C to 85°C) Industrial (TC = -40°C to 85°C) Automotive, A1 (TC = -40°C to 85°C) Automotive, A2 (TC = -40°C to 105°C) options

Overview

Clock: CK and CK# are differential clock inputs. All Double Data Rate (DDR) CA inputs are sampled on both positive and negative edge of CK. Single Data Rate (SDR) inputs, CS# and CKE, are sampled at the positive Clock edge. Clock is defined as the differential pair, CK and CK#. The positive Clock edge is defined by the crosspoint of a rising CK and a falling CK#. The negative Clock edge is defined by the crosspoint of a falling CK and a rising CK#. Clock Enable: CKE HIGH activates and CKE LOW deactivates internal clock signals and therefore device input buffers and output drivers. Power savings modes are entered and exited through CKE transitions. CKE is considered part of the command code. See Command Truth Table for command code descriptions. CKE is sampled at the positive Clock edge. Chip Select: CS# is considered part of the command code. See Command Truth Table for command code descriptions. CS# is sampled at the positive Clock edge. DDR Command/Address Inputs: Uni-directional command/address bus inputs. CA is considered part of the command code. See Command Truth Table for command code descriptions. Data Inputs/Output: Bi-directional data bus.